Rheem Performance XG55T06EN45U0 Manual de Instruções descarregar pdf (Página 13)

13

Heat Trap

For increased energy efficiency, some

water heaters have been supplied with

factory installed 3/4” NPT heat traps in

the hot outlet line and cold water inlet

line.

These heat traps may require a minimum

of one (1) 90° 3/4” NPT elbow and may

require an additional 90° 3/4” NPT elbow

or a 3/4” coupling depending on your

installation needs. See Illustration of

nipples and heat traps on page 23.

For increased energy efficiency, some

water heaters have been supplied with

two 24” sections of pipe insulation.

Please install the insulation, according

to the illustrations above, that best meets

your requirements.

Typical vertical piping arrangement

Typical horizontal piping arrangement

Hot and Cold Pipe Insulation Installation

For increased energy efficiency, this

water heater has been supplied with a

2 3/8” section of T&P insulation. Please

install the insulation as shown below.

Typical Top Connect T & P Arrangement.

T&P Insulation Installation

Typical Side Connect T & P Arrangement.

Slip the insulation cover over the T&P

Valve through the center hole and align

the hole in the side with the opening of the

T&P Valve.

Ensure the T&P Valve opening is not

obstructed by the insulation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comentários a estes Manuais

Sem comentários